Rigid Servo Mount Bracket Holder Set with Screws for RC ERA C170 Apache

Eliminate Servo Case Flex, Stop Unwanted Cyclic Deflection, and Secure Razor-Sharp Swashplate Linkage Geometry

The servo mount assembly is the structural foundation that locks your high-speed cyclic servos directly into the helicopter's internal chassis. In 3D stunt mode, executing violent collective maneuvers and rapid pitch pumps causes the swashplate linkages to push and pull hard against the servo gears. If your factory mount cracked or stretched during a blade-strike crash, the entire servo body will flex and tilt under load. This minute structural flexing introduces mechanical steering deadband, making your heli wobble during precision hovers and track unevenly in tight inverted loops. Replacing your fatigued or warped brackets with this factory-original RC ERA C170 servo mount set locks your steering actuators back into a rock-solid foundation, restoring crisp cyclic responses and maintaining accurate pitch geometry.  Ships worldwide.

Product Highlights

• Reinforced High-Rigidity Composite Matrix: Molded from premium impact-resistant polymer blends designed to hold servo cases under high torsional forces without bowing or bending.

• Precision Dual-Piece Overlapping Plate Design: Features a main alignment cradle bracket and a secondary matching lock plate to completely sandwich and immobilize your mini servos.

• Molded Indexing and Mounting Alignment Guide Pins: Built with exact millimeter-tolerance locating columns to seamlessly align with the factory RC ERA C170 interior frame plates.

• All-In-One Self-Tapping Fastener Pack: Comes complete with 4 factory-spec replacement screws, saving you from trying to reuse stripped or lost hardware during a major mechanical teardown.

Compatibility

For the RC ERA C170 1:48 Scale Longbow Apache RC Helicopter only.
Full model page (specs & photos):

https://www.kidstoylover.com/collections/rc-era-c184-rc-helicopter-spare-parts-accessories

What’s in the Box

• 1 x RC ERA C170 Servo Mount Set

Install Tips

• Extracting the Damaged Mounting Bracket: Unfasten the retaining screws holding the old cracked bracket to the main chassis; unplug your servo leads from the main board and slide the complete sub-assembly outward out of the frame.

• Seating and Interlocking the Servo Case: Place your cyclic servos squarely into the main composite bracket slots; place the matching small retention plate over the servo tabs, ensuring the molded locator rings align perfectly with the case flanges.

• Fastening the Complete Set to the Airframe: Drive the four included factory steel screws through the mounting plates and into your helicopter's primary structural framework, tightening until snug without over-torqueing into the plastic thread bores.

• Pre-Flight Mechanical Linkage Geometry Inspection: Reconnect your pushrod linkages to the swashplate and power on your 2.4G transmitter to check center points; verify that the servo bodies sit absolutely rigid with zero shifting or tilting when cycling the sticks before taking off into advanced 3D flight routines.

Spare Parts & Accessories

Find remote control，battery，USB，carcase clips，screwdriversand more in the dedicated parts collection

https://www.kidstoylover.com/collections/rc-era-c170-rc-helicopter-spare-parts-accessories

Support & Warranty

• 3-month warranty on manufacturing defects
• Ships worldwide