Qidi560 Nose Mount Bracket Front Motor Holder for Moore M7 RC Plane

Restore Structural Integrity, Eliminate Motor Vibration, and Protect Your Fuselage from Nose Collisions

Front-end nose impacts and rough off-road belly landings with the Qidi560 Moore M7 4CH Brushless RC Plane can easily crack or deform the internal plastic motor mount. A loose or damaged nose bracket causes severe motor shaft vibration, misaligned thrust angles, and erratic flight performance, which can destabilize the onboard flight gyro or snap prop shafts mid-air. Attempting to glue broken plastic brackets back together rarely holds up against high-torque brushless power. This official factory replacement Qidi560 Nose Mount Bracket completely resolves motor alignment issues. Molded from high-impact composite plastic, it securely locks the front motor in place, restores the factory thrust line, and provides a reinforced structural framework inside the EPP foam nose bay.  Ships worldwide.

Product Highlights

• Precision Factory-Molded Fit: Custom-engineered specifically for the Qidi560 Moore M7 fuselage contours, ensuring exact screw hole alignment and seamless snap-in fitting.

• High-Impact Composite Material: Constructed from tough, lightweight white engineering polymer designed to absorb landing shocks and resist motor torque twisting.

• Optimal Thrust Angle Alignment: Restores built-in down-thrust and side-thrust angles, ensuring your brushless motor delivers smooth, straight-line power without pulling or drifting.

• Integrated Screw Mounting Ports: Features pre-formed screw bosses and side locking tabs to securely anchor the motor assembly, front cowl, and inner EPP nose foam.

Compatibility

For the Qidi560 Moore M7 4CH Brushless RC Plane only.
Full model page (specs & photos):

https://www.kidstoylover.com/en-sg/products/qidi560-moore-m7-4ch-brushless-rc-plane

What’s in the Box

• 1 x Qidi560 Nose Mount Bracket

Install Tips

• Removing Damaged Front Hardware: Unmount the front propeller and cowling; carefully detach the old or broken nose bracket from the forward EPP foam fuselage compartment.

• Seating the Replacement Bracket: Align the side tabs and mounting posts of the new white bracket into the molded recess inside the Qidi560 Moore M7 nose bay; apply foam-safe adhesive if required by the airframe structure.

• Securing Motor and Screws: Align your brushless motor base onto the center screw bosses; tighten the mounting screws evenly in a diagonal cross pattern to ensure flat seating without over-tightening the plastic.

• Pre-Flight Thrust Line Check: Spin the propeller by hand to verify smooth clearance with the front cowl, then perform a low-throttle spin test to confirm zero wobble or unwanted vibration before taking off.

Support & Warranty

• 3-month warranty on manufacturing defects
• Ships worldwide