WLtoys XK X450 Transmitter 2.4GHz 6CH Remote Controller for VTOL RC Airplane（mode1/mode2）

Restore Full VTOL Mode Switching, Eliminate Signal Loss, and Regain Precise Flight Control

A damaged, water-exposed, or lost remote control on your WLtoys XK X450 Brushless VTOL Aircraft prevents you from operating the critical tilt-rotor mechanisms that transition between multirotor hover and high-speed horizontal flight. Using uncalibrated third-party radio controllers risks binding failures, signal latency, and losing access to dedicated 3D aerobatic and 6G auto-leveling stabilization modes. This official WLtoys XK X450 Transmitter delivers a direct factory replacement. Pre-programmed with original protocol firmware and multi-channel VTOL mixing, it restores rock-solid 2.4GHz signal transmission, seamless vertical takeoff control, and responsive long-range flight performance.

Key Features

• Dedicated Mode & VTOL Switch Buttons: Features factory-configured toggle switches for instant switching between Vertical Hover (VTOL), 6G Horizontal Aerobatic Flight, and 3D Stunt Mode.

• Anti-Interference 2.4GHz Protocol: Delivers stable, long-range control distance exceeding 300 meters with zero frequency interference from nearby aircraft.

• Ergonomic Precision Joysticks: High-sensitivity gimbal sticks provide smooth throttle response and accurate 6-channel pitch, roll, yaw, and motor tilt commands.

• Clear LED Status Display: Built-in battery voltage readout and signal indicator ensure clear monitoring during pre-flight setups.

Compatibility

• Model: WLtoys XK X450 (VTOL RC airplane)

• Main product link: WLtoys XK X450 2.4G 6CH 3D/6G Brushless VTOL

Installation Tips

• Transmitter Battery Installation: Insert fresh AA alkaline batteries into the rear compartment, observing correct polarity, and slide the battery door shut.

• Frequency Binding Procedure: Power on the WLtoys XK X450 Transmitter, plug the battery into your X450 aircraft on a level surface, and wait for the status LED to stay solid green to confirm frequency lock.

• Checking Motor Tilt & Control Surfaces: Operate the flight mode toggle switch to verify that the front tilt-rotor servos move smoothly between vertical hover and horizontal cruise positions.

• Pre-Flight Gyro & Stick Trim Calibration: Execute the stick-calibration sequence by pulling both control sticks down to reset the 6G gyro horizon before taking off.

What’s in the Box

1× WLtoys XK X450 Transmitter（mode1/mode2）

Transmitter Mode Guide