Não foi possível carregar a disponibilidade de retirada.
RC ERA C123 Receiver Board (Flight Controller) — Genuine Replacement
Restore factory flight performance on your RC ERA C123 6CH Brushless RC Helicopter with this OEM receiver/flight-controller board. It integrates the 2.4 GHz receiver, gyro stabilization, and ports for the C123’s brushless ESC, servos, tail system and optical-flow module, delivering the same smooth, predictable handling as the stock unit.
Highlights
Direct fit: Mounting pattern, connectors and wire lengths match the original C123 board.
All-in-one design: Built-in 2.4 GHz receiver, flight controller, gyro and power distribution.
Stability you trust: Pre-tuned for the C123 airframe, three speed/mode support.
Plug-and-play: Labeled sockets for motor/ESC, servos, tail motor, optical-flow and battery.
Clean install: Lightweight PCB keeps CG and wiring neat for reliable performance.
Compatibility
Designed specifically for the RC ERA C123 (Mode 1 or Mode 2 transmitter). If adapting to other models, confirm connector types, channel mapping, ESC/tail outputs and sensor requirements.
What’s in the Box
Receiver/flight-controller board for RC ERA C123 (no screws; reuse original hardware)
Installation Tips
Disconnect the flight battery before servicing. Observe polarity on every plug.
Note each connector location on the old board (photos help) and transfer one-by-one.
Install with the orientation arrow/label facing forward; keep the board level.
Avoid overtightening; use foam tape where supplied to reduce vibration.
Binding & Setup
After replacement, re-bind to your transmitter (follow your radio’s bind steps). Indicators on the board will confirm a successful link.
Power up on a level surface and keep the heli still for gyro initialization.
If equipped, ensure the optical-flow sensor window is clean and unobstructed.
Note: This is a factory-spec board. Third-party firmware flashing is not supported.
Care & Safety
Keep connectors seated fully; check after hard landings.
Do not expose the PCB to moisture; store and transport in an antistatic bag.
If you see abnormal heat or persistent drift, land and re-inspect wiring and mounting.
Power loss and a flashing light on your standard C138? Start with these battery and connection checks, then see what information to send support before flying again.
Power loss and a flashing light on your standard C138? Start with these battery and connection checks, then see what information to send support before flying again.
Compare the QIDI-590 and MoFly MF-X7 by transmitter layout, flight modes, battery packages and prices. Named reviewers’ observations and linked sources explain which differences matter before you buy.
Compare the QIDI-590 and MoFly MF-X7 by transmitter layout, flight modes, battery packages and prices. Named reviewers’ observations and linked sources explain which differences matter before you buy.