RC ERA C123 Nose Cone (Front Cover) — OEM Replacement

Restore the clean, aerodynamic front-end of your RC ERA C123 6CH Brushless RC Helicopter with this factory nose cone/front cover. It matches the original shape and mounting points, protecting electronics while giving your canopy a like-new finish.

Highlights

• Direct fit: Same dimensions and clips/screw locations as the stock C123 nose piece.
• Protective cover: Shields receiver board, wiring and battery bay from light impacts and debris.
• Lightweight: Maintains CG and flight performance; no trimming required.
• Clean look: Smooth molded surface to refresh the helicopter’s appearance.

Compatibility

Designed specifically for the RC ERA C123. If adapting to other models, confirm length/width, canopy interface and fastener style.

What’s in the Box

• RC ERA C123 nose cone / front cover (color/finish as shown in product images)

Note: Screws, clips or grommets typically reuse your original hardware unless otherwise indicated.

Installation Tips

• Power off and remove the battery before fitting the nose cone.
• Route wires neatly; avoid pinching leads between the cover and canopy.
• Do not overtighten; snug the screws to prevent cracking plastic mounts.
• Verify full cyclic/tail movement with the cover installed before flight.

Care & Safety

• Wipe with a soft, damp cloth; avoid harsh solvents.
• Inspect clip/screw areas after hard landings and replace if stress-whitened or cracked.

More C123 Spare Parts

Looking for batteries, landing gear, motors, rotor head, receiver board and more? Browse the full range here: RC ERA C123 Spare Parts Collection.