2-in-1 Brushless Dual ESC Speed Controller Package for RC ERA C180 BO105

Eliminate Motor Bogging, Prevent Thermal Overload Cuts, and Fix Tail Rotor Blowout Failures

When an advanced scale model experiences heavy motor bogging during pitch-pump setups, sudden tail-rotor blowout spinning while doing inverted stunts, or a total refusal to spin up despite a fresh battery pack, your internal electronic speed controller is failing. The high-stress demands of dual brushless drive systems generate immense heat; over time, aggressive 3D stunt flying can degrade the factory MOSFET switches, causing bad throttle delays or dangerous thermal brownouts mid-air. This official factory-original C180 2-in-1 brushless electronic speed controller (ESC) block offers a complete drop-in electrical refresh, re-establishing fluid motor timing, cool thermal operation, and perfectly instantaneous throttle mapping..  Ships worldwide.

Product Highlights

• Integrated Dual-Drive 2-in-1 Circuit Design: Houses independent processing nodes on a single low-impedance SMD motherboard to drive both the primary main lift motor and the high-RPM brushless tail rotor smoothly.

• Heavy-Duty High-Current Pure Silicone Power Leads: Built with ultra-flexible, heat-resistant red and black pure silicone wire leads to ensure safe, loss-free current flow between components without risk of melting.

• Gold-Plated Solid Core 5-Pin Dedicated Battery Interface Deck: Outfitted with a high-grade terminal connection deck that guarantees a rock-solid, zero-resistance connection to your modular flight batteries.

• Premium Soft Damping Silicone Mechanical Dampers: Includes two matching black anti-vibration rubber columns that isolate the sensitive electronics from motor-induced chassis vibrations, protecting the SMD elements from micro-cracking.

Compatibility

For the RC ERA C180 1:25 Scale BO105 6-Channel Brushless RC Helicopter only.
Full model page (specs & photos):

https://www.kidstoylover.com/products/rc-era-c180

What’s in the Box

• 1 x RC ERA C180 ESC Block

Install Tips

• Dual-Drive 2-in-1 ESC Board Insertion: Remove your scale BO105 fuselage shell and slide the ESC processor board into its dedicated lower cradle section inside the composite main frame rails; confirm that the heavy power wire runs are organized away from any sharp spinning plastic gear teeth to avoid chaffing.

• Anti-Vibration Damping Silicone Columns Installation: Slide the two black silicone soft rubber damping mounting strips onto the specific plastic frame rails; press the integrated rubber alignment tabs fully into the chassis tracking channels, providing a cushioned barrier to isolate the ESC from flight harmonics.

• C180BAT Modular Power Deck Seat Alignment: Fasten the dedicated 5-pin battery terminal interface board securely into the primary entry track at the front of the lower battery rail deck; ensure the gold connector pins line up straight so the modular smart battery clicks smoothly into place.

• Pre-Flight Initialization and Commutator Throttle Calibration: Plug all multi-pin receiver connection leads directly into your main flight controller ports; power on your multi-channel radio control transmitter station and boot the helicopter on a flat pad, keeping it still while the ESC plays its official startup chimes and registers full throttle range.

More RC ERA C180 Spare Parts

Support & Warranty

• 3-month warranty on manufacturing defects
• Ships worldwide