Volantex F4U Receiver Board Xpilot Gyro Flight Controller for 400mm RC Warbird

Restore Gyro Self-Leveling, Fix Signal Disconnections, and Eliminate Flight Instability

A burnt-out, damaged, or signal-dropping main receiver circuit board on your VolantexRC F4U Corsair 400mm 4CH Warbird completely grounds your aircraft. Hard crashes, moisture exposure, or power surges can damage onboard gyro sensors, leading to erratic servo movement, failure to bind with the transmitter, or loss of Xpilot 6-axis stabilization self-leveling mid-flight. Attempting to install generic non-calibrated flight controllers requires complex soldering and ruins the pre-programmed one-key aerobatic software. This official Volantex F4U Receiver Board delivers a plug-and-play factory replacement. Pre-loaded with official Xpilot stabilization firmware and factory servo connectors, it restores rock-solid signal reception, precise multi-mode gyro auto-leveling, and smooth 4-channel flight control.

Product Highlights

• Integrated 6-Axis Xpilot Gyro System: Pre-calibrated flight controller algorithm providing Beginner, Intermediate, and Expert flight modes for effortless stability.

• Built-in One-Key Aerobatic & U-Turn Functionality: Fully compatible with original Volantex transmitters to execute automated aerobatic flips and return assistance.

• Factory Micro Servo & Power Sockets: Features dedicated pre-soldered pin connectors for seamless plug-and-play connection to aileron, rudder, and elevator servos.

• Compact Lightweight Form Factor: Ultra-light PCB design fits perfectly into the molded fuselage bay without affecting airframe weight distribution or center of gravity.

Compatibility

For the Volantex F4U Corsair 400mm 4CH RC Warbird only.
Full model page (specs & photos):
https://www.kidstoylover.com/products/f4u-corsair-400mm-4ch-rc-warbird

What’s in the Box

• 1 × Volantex F4U 400mm Corsair 4CH Receiver Board
  

Install Tips

• Mounting Board in Fuselage: Apply double-sided foam mounting tape and secure the Volantex F4U Receiver Board perfectly flat and parallel to the airframe centerline inside the radio bay.

• Connecting Servo & Motor Cables: Plug the main motor lead, elevator servo, rudder servo, and aileron servo cables into their corresponding labeled board sockets until fully seated.

• Transmitter Re-Binding Procedure: Turn on your transmitter, insert a fresh 1S LiPo battery, and allow the status LED to turn solid green, confirming frequency bind.

• Pre-Flight Gyro Horizon Calibration: Place the F4U Corsair on a completely level surface and pull both transmitter control sticks down and outward to reset the 6-axis gyro horizon before launch.

Support & Warranty

• 3-month warranty on manufacturing defects
• Ships worldwide