WLtoys XK X450 Transmitter 2.4GHz 6CH Remote Controller for VTOL RC Airplane（mode1/mode2）
Restore Full VTOL Mode Switching, Eliminate Signal Loss, and Regain Precise Flight Control
A damaged, water-exposed, or lost remote control on your WLtoys XK X450 Brushless VTOL Aircraft prevents you from operating the critical tilt-rotor mechanisms that transition between multirotor hover and high-speed horizontal flight. Using uncalibrated third-party radio controllers risks binding failures, signal latency, and losing access to dedicated 3D aerobatic and 6G auto-leveling stabilization modes. This official WLtoys XK X450 Transmitter delivers a direct factory replacement. Pre-programmed with original protocol firmware and multi-channel VTOL mixing, it restores rock-solid 2.4GHz signal transmission, seamless vertical takeoff control, and responsive long-range flight performance.
Key Features
-
Dedicated Mode & VTOL Switch Buttons: Features factory-configured toggle switches for instant switching between Vertical Hover (VTOL), 6G Horizontal Aerobatic Flight, and 3D Stunt Mode.
-
Anti-Interference 2.4GHz Protocol: Delivers stable, long-range control distance exceeding 300 meters with zero frequency interference from nearby aircraft.
-
Ergonomic Precision Joysticks: High-sensitivity gimbal sticks provide smooth throttle response and accurate 6-channel pitch, roll, yaw, and motor tilt commands.
-
Clear LED Status Display: Built-in battery voltage readout and signal indicator ensure clear monitoring during pre-flight setups.
Compatibility
More Spare Parts & Accessories
Find exact-fit props, wheels, servos and more in the dedicated parts collection:
https://www.kidstoylover.com/collections/wltoys-xk-x450-6ch-brushless-airplane-spare-parts
Installation Tips
-
Transmitter Battery Installation: Insert fresh AA alkaline batteries into the rear compartment, observing correct polarity, and slide the battery door shut.
-
Frequency Binding Procedure: Power on the WLtoys XK X450 Transmitter, plug the battery into your X450 aircraft on a level surface, and wait for the status LED to stay solid green to confirm frequency lock.
-
Checking Motor Tilt & Control Surfaces: Operate the flight mode toggle switch to verify that the front tilt-rotor servos move smoothly between vertical hover and horizontal cruise positions.
-
Pre-Flight Gyro & Stick Trim Calibration: Execute the stick-calibration sequence by pulling both control sticks down to reset the 6G gyro horizon before taking off.
What’s in the Box
1× WLtoys XK X450 Transmitter（mode1/mode2）
Transmitter Mode Guide
Mode 2 (Left-Hand Throttle):
Left Stick: Throttle (Up/Down) & Rudder (Left/Right)
Right Stick: Elevator (Up/Down) & Aileron (Left/Right)
(Recommended for beginners and standard setup in most countries).
Mode 1 (Right-Hand Throttle):
Right Stick: Throttle (Up/Down) & Aileron (Left/Right)
Left Stick: Elevator (Up/Down) & Rudder (Left/Right)
(Preferred by some experienced pilots for precise aerobatic control).
