Cyclic Servo Mount Bracket Holder Set with Screws for RC ERA C184 MD530

Eradicate Servo Flex, Prevent Steering Slop, and Lock In Rock-Solid Cyclic Swashplate Alignment

During aggressive scale banking maneuvers or rapid altitude corrections, your three cyclic servos execute thousands of micro-adjustments per minute. If the servo mounting brackets are cracked, warped, or have stripped screw holes, the servo cases will physically flex and twist within the chassis under load. For the 1/48 scale RC ERA C184 MD530, this subtle movement introduces serious mechanical steering lag and blade tracking slop, which ultimately ruins the precise automated telemetry of the downward-facing optical flow positioning sensor. Replacing your worn casing anchor with this factory-original high-rigidity servo clamping plate completely locks your micro steering gear boxes into dead-center alignment, eliminating unprovoked drifting and restoring factory-crisp swashplate response.  Ships worldwide.

Product Highlights

• One-Piece 3-Slot Structural Tray: Precision-molded to interlock all three cyclic steering servos into a unified structural block, distributing mechanical pushrod stress evenly across the inner chassis framework.

• Impact-Resistant Lightweight Polymer: Injection-molded from a high-tensile composite matrix that absorbs high-frequency motor vibrations without adding structural weight or stressing the brushless core.

• Four Factory-Toleranced Retention Screws: Comes packed with four precision-machined steel hardware fasteners sized perfectly to clamp down the upper retention plate without over-compressing your servo cases.

• Flush-Fit Anti-Twist Containment Walls: Molded with tight-tolerance interior alignment channels that clip securely over micro-servo tabs to ensure zero lateral or vertical casing slip during high-speed low-pass flights.

Compatibility

For the RC ERA C184 MD530 only.
Full model page (specs & photos):

https://www.kidstoylover.com/collections/rc-era-c184-rc-helicopter-spare-parts-accessories

What’s in the Box

• 1 x RC ERA C184 Servo Mount

Install Tips

• Removing the Damaged Servo Retention Frame: Unthread the perimeter shell screws to open up your red and white civil fuselage casing; back out the four worn clamping screws to remove the broken servo bracket plate from the upper chassis deck.

• Seating Servos Into the Compartment Bed: Clean away dust or debris from the main plastic frame tracks; place your three micro cyclic servos side-by-side into their designated mounting bays, making sure the wiring looms path cleanly away from the spinning white main drive gears.

• Securing the Clamping Plate and Hardware Screws: Lay the new black servo mount bracket square over the servo alignment tabs; drop the four included metal screws into the perimeter holes and tighten them evenly until snug, ensuring you do not over-torque and strip out the lower composite core receiver tracks.

• Pre-Flight Swashplate Leveling Verification: Power up your wireless radio remote controller and connect the main flight battery to let the servos center automatically; verify that all pushrod linkages run parallel and that the metal swashplate ring stays perfectly level, providing a vibration-free platform for the internal optical flow camera sensor to read altitude data smoothly.

Spare Parts & Accessories

Find remote control，battery，USB，carcase clips，screwdriversand more in the dedicated parts collection

https://www.kidstoylover.com/collections/rc-era-c184-rc-helicopter-spare-parts-accessories

Support & Warranty

• 3-month warranty on manufacturing defects
• Ships worldwide