VolantexRC 76210 2-Blade Propeller Set for B-25 Mitchell 3CH RC Plane

Restore Twin-Engine Thrust, Replace Damaged Blades, and Eliminate Flight Tracking Drift

A chipped, bent, or missing propeller on your VolantexRC 76210 B-25 Mitchell 3CH 400mm RC Airplane causes unequal twin-engine thrust, severe power loss, and violent motor vibrations mid-flight. Ground strikes, grass landings, or transport bumps can easily crack or snap lightweight twin-engine propellers. Flying with damaged props spoils aerodynamic pitch balance, strain motor gearboxes, and leads to uncommanded flight yawing during takeoffs and scale cruising. This official VolantexRC 76210 2-Blade Propeller set provides a direct factory replacement. Molded from impact-resistant composite material with optimal airfoil pitch curvature, it restores smooth thrust output, scale twin-engine efficiency, and rock-solid flight stability.  Ships worldwide.

Product Highlights

• Impact-Resistant Composite Material: Engineered with high-flex polymer to withstand rough field landings and minor prop strikes without snapping easily.

• Factory Twin-Engine Pitch Calibration: Precision-balanced blade geometry delivers balanced thrust output across both motor pods for smooth straight-line flight.

• Seamless Prop Saver Fitment: Snaps perfectly onto the original gearbox prop saver shaft adaptor, protecting internal motor gears during accidental ground impact.

• Ultra-Lightweight Efficiency: Preserves factory motor RPM and battery flight runtime without adding rotational drag to your twin-motor setup.

Compatibility

For the VolantexRC 76210 B-25 Mitchell 3CH 400mm RC Plane only.

Full model page (specs & photos):

https://www.kidstoylover.com/products/volantexrc-76210-b-25-mitchell-3ch-400mm-rc-plane

What’s in the Box

• 1 x VolantexRC 76210 B-25 Mitchell 3CH RC Plane -2-Blade Propeller Set

Install Tips

• Removing Damaged Propeller: Gently unsnap or press off the damaged 2-blade propeller from the motor gearbox prop saver adapter pin.

• Inspecting Shaft & Saver Adapter: Check that the motor output shaft and plastic prop saver retainer are clean, straight, and free of debris before mounting.

• Snapping New Propeller into Place: Press the center hub of the VolantexRC 76210 2-Blade Propeller squarely onto the adapter pin until it seats tightly against the rubber ring/latch.

• Pre-Flight Rotation & Thrust Check: Spin both propellers by hand to verify unobstructed rotation, then perform a brief low-throttle ground test to ensure vibration-free thrust.

Support & Warranty

• 3-month warranty on manufacturing defects
• Ships worldwide