VolantexRC Trainstar 500mm PNP Version Brushless RC Plane 

Save Money on Spare Gear, Reuse Your Own Transmitter, and Rapidly Fix Severe Crash Damage

What does PNP (Plug and Play) mean? The PNP version is designed for experienced pilots and hobbyists who already own a compatible radio transmitter, receiver, 2S/3S LiPo batteries, and a charger. It includes the fully factory-assembled VolantexRC Trainstar 500mm airframe pre-installed with the brushless motor, electronic speed controller (ESC), flight stabilization gyro, control servos, and pushrods. It does NOT include the transmitter, receiver, LiPo battery, or charger, allowing you to avoid paying for duplicate gear. When a heavy crash, nose-in impact, or mid-air tree collision severely damages your high-wing trainer’s fuselage or main wing, buying a full Ready-to-Fly (RTF) kit is an unnecessary expense. This official PNP version of the VolantexRC Trainstar 500mm solves that problem completely. Simply transfer your existing battery, plug in your receiver, and bind your transmitter to this factory-built replacement airframe to get back in the air with minimal downtime and cost.  Ships worldwide.

Product Highlights

• Factory-Installed 2S/3S Brushless Powerplant: Comes pre-fitted with a high-torque brushless motor and ESC capable of handling both 2S LiPo for smooth beginner cruising and 3S LiPo for punchy vertical climbs.

• Integrated Gyro Flight Controller & Servos: Equipped with factory-calibrated flight stabilization and micro servos for self-leveling stability and immediate control surface response.

• High-Wing Stability & Durable EPP Foam: The stable high-wing trainer geometry paired with impact-resistant EPP foam construction withstands hard landings and accidental bumps.

• Factory-Matched Trim & Hardware: Includes pre-mounted landing gear, main wings, tail section, and propeller assembly perfectly aligned for aerodynamic balance right out of the box.

Compatibility

For the VolantexRC Trainstar 500mm Brushless RC Plane only.
Full model page (specs & photos):

https://www.kidstoylover.com/products/volantexrc-trainstar-500mm-brushless-rc-plane

What’s in the Box

• 1 x VolantexRC Trainstar 500mm PNP
  
  PNP stands for "Plug-and-Play".
  
  What is NOT included: This version does NOT include a transmitter (remote control), battery, or charger.

Installation & Charging Tips

• Connecting Your Receiver: Connect your 4CH or 6CH receiver channel leads (Aileron, Elevator, Rudder, Throttle) into the pre-wired signal harness inside the Trainstar fuselage battery compartment.

• Installing the Battery and CG Alignment: Slide your 2S or 3S LiPo battery into the forward battery bay, adjusting its position until the aircraft balances flat at the recommended Center of Gravity (CG) mark under the main wing.

• Transmitter Binding and Gyro Initialization: Power on your transmitter first, connect the flight battery with the plane placed on a level ground surface, and allow 3-5 seconds for the onboard stabilization gyro to complete auto-calibration.

• Control Surface Alignment & Motor Spin Check: Visually check that the ailerons, elevator, and rudder align flush in neutral joystick position, then advance the throttle stick slowly to confirm correct propeller rotation direction before taking off.

Support & Warranty

• 3-month warranty on manufacturing defects
• Ships worldwide