VolantexRC Spitfire 400mm (761-12) Push Rod Full Set

Overview

Restore crisp, precise control to your VolantexRC Spitfire 400mm with this genuine Push Rod Full Set. Engineered to factory spec, these pre-bent steel linkages replace worn or bent rods to bring back smooth elevator, rudder, and aileron response.

Compatibility

• Model: VolantexRC Spitfire 400mm

• Code: 761-12

• Manufacturer Part No.: P7611203

• Fits the 400mm Spitfire series with XPilot stabilization.

What’s in the Box

• Complete set of pre-formed push rods for primary control surfaces (elevator, rudder, ailerons)

• Hook/clevis bends as per original design for easy drop-in fit

Key Features

• OEM geometry for accurate throws and neutral trims

• Durable stainless/steel wire resists bending and corrosion

• Lightweight design preserves CG and flight time

• Ready-to-install with no cutting or re-bending required

Installation Tips

1. Power off the aircraft and center servos before installation.

2. Match each rod to its original location and orientation.

3. Connect to servo horns and control horns using existing hardware.

4. Verify neutral alignment; fine-tune by adjusting the Z-bend/clevis position.

5. Perform a control-surface direction and range check before flight.

Notes

• Designed specifically for Spitfire 400mm (761-12); not compatible with other 400mm warbirds unless specified by the manufacturer.

• If linkages were damaged in a crash, inspect horns and servo arms for cracks and replace if needed.