Passer aux informations produits
1 de 1

Kidstoylover

WLtoys XK X450 émetteur 2.4GHz 6CH télécommande pour avion VTOL RC

WLtoys XK X450 émetteur 2.4GHz 6CH télécommande pour avion VTOL RC

Prix habituel 2,820.00 TRY
Prix habituel Prix promotionnel 2,820.00 TRY
En vente Épuisé
Frais d'expédition calculés à l'étape de paiement.
Mode

WLtoys XK X450 Transmitter 2.4GHz 6CH Remote Controller for VTOL RC Airplane(mode1/mode2)


Restore Full VTOL Mode Switching, Eliminate Signal Loss, and Regain Precise Flight Control

A damaged, water-exposed, or lost remote control on your WLtoys XK X450 Brushless VTOL Aircraft prevents you from operating the critical tilt-rotor mechanisms that transition between multirotor hover and high-speed horizontal flight. Using uncalibrated third-party radio controllers risks binding failures, signal latency, and losing access to dedicated 3D aerobatic and 6G auto-leveling stabilization modes. This official WLtoys XK X450 Transmitter delivers a direct factory replacement. Pre-programmed with original protocol firmware and multi-channel VTOL mixing, it restores rock-solid 2.4GHz signal transmission, seamless vertical takeoff control, and responsive long-range flight performance.


Key Features

  • Dedicated Mode & VTOL Switch Buttons: Features factory-configured toggle switches for instant switching between Vertical Hover (VTOL), 6G Horizontal Aerobatic Flight, and 3D Stunt Mode.

  • Anti-Interference 2.4GHz Protocol: Delivers stable, long-range control distance exceeding 300 meters with zero frequency interference from nearby aircraft.

  • Ergonomic Precision Joysticks: High-sensitivity gimbal sticks provide smooth throttle response and accurate 6-channel pitch, roll, yaw, and motor tilt commands.

  • Clear LED Status Display: Built-in battery voltage readout and signal indicator ensure clear monitoring during pre-flight setups.


Compatibility


Installation Tips

  • Transmitter Battery Installation: Insert fresh AA alkaline batteries into the rear compartment, observing correct polarity, and slide the battery door shut.

  • Frequency Binding Procedure: Power on the WLtoys XK X450 Transmitter, plug the battery into your X450 aircraft on a level surface, and wait for the status LED to stay solid green to confirm frequency lock.

  • Checking Motor Tilt & Control Surfaces: Operate the flight mode toggle switch to verify that the front tilt-rotor servos move smoothly between vertical hover and horizontal cruise positions.

  • Pre-Flight Gyro & Stick Trim Calibration: Execute the stick-calibration sequence by pulling both control sticks down to reset the 6G gyro horizon before taking off.


What’s in the Box

1× WLtoys XK X450 Transmitter(mode1/mode2)


Transmitter Mode Guide

Mode 2 (Left-Hand Throttle):

Left Stick: Throttle (Up/Down) & Rudder (Left/Right)
Right Stick: Elevator (Up/Down) & Aileron (Left/Right)
(Recommended for beginners and standard setup in most countries).

Mode 1 (Right-Hand Throttle):

Right Stick: Throttle (Up/Down) & Aileron (Left/Right)
Left Stick: Elevator (Up/Down) & Rudder (Left/Right)
(Preferred by some experienced pilots for precise aerobatic control).

 

Afficher tous les détails
1 de 4